We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
DGD-2501 Pentek Whole House Filter Replacement Cartridge
SKU
PENTEK-DGD-2501
Price $25.79 List Price Price $36.99 Save 30%
Availability: In Stock
Fits Pentek Big Blue and other heavy-duty filter housings
Choose a quantity
1 filter $25.79 6 filters $23.21 each 12 filters $19.34 each 20 filters $18.55 each
- Dual-Gradient Density (DGD) offers a 25 micron pre-filter and 1 micron post-filter in one cartridge
- Effective filter depth is increased to a full 233% of standard spun-polypropylene or string-wound filters
- Spun fibers form a true gradient density from outer to inner surfaces
- Manufactured from pure 100% polypropylene
› See more product details
- Dual-Gradient Density (DGD) offers a 25 micron pre-filter and 1 micron post-filter in one cartridge
- Effective filter depth is increased to a full 233% of standard spun-polypropylene or string-wound filters
- Spun fibers form a true gradient density from outer to inner surfaces
- Manufactured from pure 100% polypropylene
The PENTEK-DGD-2501 heavy duty filter cartridge is manufactured from 100% pure polypropylene and is sized for use in Big Blue and other heavy-duty filter housings. The DGD-2501 cartridge uses a performance enhancing dual-gradient density filtration to achieve up to three times the dirt-holding capacity of similar size sediment cartridges. The increased depth of the filter media provides for very high particulate reduction efficiencies and makes it an excellent choice for all residential, rural, municipal and commercial applications.
Reduced Contaminants
The PENTEK-DGD-2501 reduces the following contaminants:
- Dirt
- Extra Fine Sand
- Fine Sand
- Rust and Corrosion
- Sand
- Sediment
- Silt
The PENTEK-DGD-2501 is comparable with the following part numbers
155359-43 | DGD-2501 |
FPMB-BB1-10 | PENTEK-DGD-2501 |
SDC-45-1001 | SDF-45-1001 |
User Guide
Instructions
- Turn off water supply. Press red pressure-relief button (if present).
- Unscrew housing. Remove large o-ring, wipe clean and set aside.
- Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly.
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove.
- Insert new filter cartridge.
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.