We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
40 inch x 2.5 inchWhole House Sediment Water Filter by Tier1 (75 Micron)
SKU
TIER1-P75-40
Price $14.99 List Price Price $20.99 Save 28%
Availability: Discontinued
Fits housings that accept 40 x 2.5 inch sized filters
- Ships fast!
- Greater dirt holding capacity
- Perfect cost effective filter that does not sacrifice quality
- Superb filter strength able to withstand acids and alkalies
› See more product details
The 40 inch x 2.5 inch whole house sediment water filter by Tier1 (75 Micron) Tier1-P75-40 is a spun wound polypropylene sediment filter, that has a micron rating of 75. The large surface area of the filter makes it a perfect match for filtering commercial applications. You even have a greater dirt holding capacity compared to string wound filters. This product is resistant to bacteria and chemicals in the water. Fluids such as acids and alkalis are compatible with the Tier1-P75-40. Order this filter today!
Experience the Tier1 Difference
Tier1 manufactures high-quality filtration and household products. We take creating and maintaining a healthy home seriously. Products must undergo rigorous testing and meet demanding quality expectations in order to earn the Tier1 badge. Every purchase is backed by the Tier1® Guarantee:
- Guaranteed Fit
- Guaranteed Quality
- Guaranteed Price
Reduced Contaminants
The TIER1-P75-40 reduces the following contaminants:
- Dirt
- Particles
- Sediment
The TIER1-P75-40 is comparable with the following part numbers
SDC-25-4075 |
Instructions
- Turn off water supply. Press red pressure-relief button (if present)
- Unscrew housing. Remove large o-ring, wipe clean and set aside
- Discard used filter cartridge
- Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
- Insert new filter cartridge
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation