We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
10 inch x 2.5 inch Pleated Sediment Water Filter by Tier1 (1 Micron)
SKU
TIER1-SPC-25-1001
Recommended Replacement
Price $12.99 List Price Price $18.99 Save 31%
Availability: Discontinued
1 micron filter, sized 9 7/8x2.5 inches
Choose a quantity
1 filter $12.99 6 filters $11.69 each
- Ships fast!
- Both resistant to chemicals and bacteria
- Greater dirt holding capacity compared to other aftermarkets
- 1 micron filter reduces small sediment particles
› See more product details
Both bacteria and chemical resistant, the 10 inch x 2.5 inch pleated sediment water filter by Tier1 (1 Micron) is perfect for reducing dirt, sand and silt out of your water supply. This filter features a pleated design that allows it to reduce more particles such as sediment and dirt in addition to other particles down to 1 micron in size. In addition this filter is ideal for use in a variety of applications, such as commercial and residential. You can even wash the pleats of this filter, at least once during it's life, for more use . Order today!
Experience the Tier1 Difference
Tier1 manufactures high-quality filtration and household products. We take creating and maintaining a healthy home seriously. Products must undergo rigorous testing and meet demanding quality expectations in order to earn the Tier1 badge. Every purchase is backed by the Tier1® Guarantee:
- Guaranteed Fit
- Guaranteed Quality
- Guaranteed Price
Reduced Contaminants
The TIER1-SPC-25-1001 reduces the following contaminants:
- Dirt
- Particulates
- Sand
- Sediment
- Silt
The TIER1-SPC-25-1001 is comparable with the following part numbers
HYDRONIX-SPC-25-1001 |
SPC-25-1001 |
SDF-25-1001 |
255481-43 |
FM-1-975 |
Instructions
- Turn off water supply. Press red pressure-relief button (if present)
- Unscrew housing. Remove large o-ring, wipe clean and set aside
- Discard used filter cartridge
- Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
- Insert new filter cartridge
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation