We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
ECP5-20BB Pentek Whole House Filter Replacement Cartridge
SKU
PENTEK-ECP5-20BB
Price $43.68 List Price Price $61.99 Save 29%
Availability: In Stock
Fits Pentek 20-inch Big Blue and any standard housing that uses 20-inch x 4 1/2-inch replacement filter cartridges
Choose a quantity
1 filter $43.68 6 filters $39.31 each
- Drop-in cartridge makes filter change fast and easy
- Resin-impregnated cellulose and polyester fibers provide higher wet strength than regular cellulose cartridges
- Recommended for chlorinated water supplies
› See more product details
- Drop-in cartridge makes filter change fast and easy
- Resin-impregnated cellulose and polyester fibers provide higher wet strength than regular cellulose cartridges
- Recommended for chlorinated water supplies
The ECP5-20BB provides high flow rates and dirt-holding capacity, while maintaining extremely low pressure drop making it ideal for a variety of uses and applications.
Reduced Contaminants
The PENTEK-ECP5-20BB reduces the following contaminants:
- Dirt
- Particles
- Rust and Corrosion
- Sand
- Sediment
- Silt
The PENTEK-ECP5-20BB is comparable with the following part numbers
255494-43 |
ECP5-20BB |
PENTEK-ECP5-20BB |
User Guide
Instructions
- Turn off water supply. Press red pressure-relief button (if present).
- Unscrew housing. Remove large o-ring, wipe clean and set aside.
- Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly.
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove.
- Insert new filter cartridge.
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.