We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
ECP5-BB Pentek Whole House Filter Replacement Cartridge
SKU
PENTEK-ECP5-BB
Price $29.09 List Price Price $41.99 Save 30%
Availability: In Stock
Fits any standard housing that uses 9 3/4-inch x 4 1/2-inch replacement filter cartridges
Choose a quantity
1 filter $29.09 6 filters $26.18 each 12 filters $21.82 each
- Drop-in cartridge makes filter change fast and easy
- Resin-impregnated cellulose and polyester fibers provide higher wet strength than regular cellulose cartridges
- Recommended for chlorinated water supplies
› See more product details
- Drop-in cartridge makes filter change fast and easy
- Resin-impregnated cellulose and polyester fibers provide higher wet strength than regular cellulose cartridges
- Recommended for chlorinated water supplies
The ECP5-BB provides high flow rates and dirt-holding capacity, while maintaining extremely low pressure drop making it ideal for a variety of uses and applications.
Reduced Contaminants
The PENTEK-ECP5-BB reduces the following contaminants:
- Dirt
- Particles
- Rust and Corrosion
- Sand
- Sediment
- Silt
The PENTEK-ECP5-BB is comparable with the following part numbers
155184 | 4021341 | 155184-27 | 255490-43 |
CP5-BB | CP5-BBS | CP5-BBS-D | ECP5-BB |
FM-BB-10-5 | GPC5 | PC05-BB-S | PENTEK-ECP5-BB |
RS15 | RS15-2-01 | RS15-2-02 | RS15-2-05 |
SPC-45-1005 | SPF-45-1005 | W5CPHD | WB-HB-10-5W |
User Guide
Instructions
- Turn off water supply. Press red pressure-relief button (if present)
- Unscrew housing. Remove large o-ring, wipe clean and set aside
- Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly.
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove.
- Insert new filter cartridge.
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.