We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
R30-BB Pentek Whole House Water Filter Replacement Cartridge
SKU
PENTEK-R30-BB
Price $30.84 List Price Price $43.99 Save 29%
Availability: In Stock
Fits the Pentek Big Blue or any other heavy duty water filtration system housing that uses 9 3/4-inch x 4 1/2-inch cartridges
Choose a quantity
1 filter $30.84 6 filters $27.76 each 12 filters $23.13 each 50 filters $20.05 each
- Ships fast!
- Washable and reusable
- Captures more dirt, while resisting bacteria and chemicals
› See more product details
- Ships fast!
- Washable and reusable
- Captures more dirt, while resisting bacteria and chemicals
Washable and reusable, the R30-BB Pentek whole house water filter replacement cartridge is an economical way to ensure the water in your home or business remains virtually free of sediment. A genuine OE part, designed by Pentek to be resistant to both bacteria and chemicals, while capturing the maximum amount of dirt. Order the replacement R30-BB Pentek whole house water filter cartridge you need today!
Reduced Contaminants
The PENTEK-R30-BB reduces the following contaminants:
- Dirt
- Sand
- Sediment
- Silt
The PENTEK-R30-BB is comparable with the following part numbers
155101-43 |
PENTEK-R30-BB |
R30-BB |
User Guide
Instructions
- Turn off water supply. Press red pressure-relief button (if present).
- Unscrew housing. Remove large o-ring, wipe clean and set aside.
- Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove.
- Insert new filter cartridge.
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.