We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
1-250-F Rusco Polyester Screened Spin-Down Water Filtration System
SKU
RUSCO-1-250-F
Price $59.99 List Price Price $85.99 Save 30%
Availability: Discontinued - Free Shipping
250 mesh, 61 micron and built to fit a one inch pipe
- Ships fast!
- Uses centrifugal separation technology to reduce sediment
- Helps significantly improve the overall quality of your drinking water!
› See more product details
The 1-250-F Rusco Spin-Down water filtration system is an ideal solution for any home dealing with drinking water sediment issues. Using cutting edge centrifugal separation technology, this system will reduce the ability of sediment to make it through your taps, significantly improving the overall quality of your water. This durably built system is also easy to maintain and clean without the use of tools, courtesy of an open ball valve that makes it easy to flush sediment. Genuine OE system. Reduce sediment issues in your drinking water by ordering and installing the 1-250-F Rusco Spin-Down water filtration system today!
Reduced Contaminants
The RUSCO-1-250-F reduces the following contaminants:
- Dirt
- Extra Fine Sand
- Sand
- Sediment
- Silt
The RUSCO-1-250-F is comparable with the following part numbers
RUSCO-1-250-F |
1-250-F |
The RUSCO-1-250-F fits the following model numbers
RUSCO-FS-1-250 |
FS-1-250 |
Installation Guide
User Guide
Instructions
- Install the filter in a location that protects it from damage such as impact, freeze, excessive heat, chemical contact and water hammer
- Install the filter in the preferred vertical position with the purge outlet pointing down and also where it can be easily accessed for cleaning and maintenance
- Install the filter on the discharge side of the pump to allow the filter to be cleaned by purging through the flush valve
- Refer to arrows on the filter body for correct water flow direction
- Adhere to all local and state codes, laws and regulations
- Use approved solvent cement for gluing PVC connections. Follow gluing instructions on glue container. REMOVE CLEAR COVER FROM THE PVC BODY PRIOR TO THE GLUING PROCESS. Any excess glue that comes in contact with the clear cover will damage it
- The Rusco filter screens should be cleaned every few months. No tools are required for cleaning. The filter screen should be replaced every 6-12 months depending on your water usage and water quality
- Clean the Rusco filter is purging separated solids through the flush valve while the filter is under system pressure. The purging process can be done manually with the flush valve or automated with our optional Automatic Flush Valve
- The filter element may need to be removed and cleaned. To remove the filter element, turn off the water supply, drain water pressure, unscrew the clear cover and remove the filter element. Wash off collected sediment by spraying with water
- Remove fine particles wedged in the screen with a soft brush. Apply silicone grease to o-rings if needed and reassemble. HAND TIGHTEN ONLY