We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
ECP50-20BB Pentek Comparable Replacement Filter Cartridge by Tier1
SKU
TIER1-ECP50-20BB
Price $27.99 List Price Price $39.99 Save 30%
Availability: BackOrder
Fits most Big Blue housings that accept 20-inch x 4.5-inch water filter cartridges
- Greater surface area, for maximum filtration
- Pleated media may be washed off at least once
- Recommended for use in chlorinated water supplies only
- A quality and cost effective filter
› See more product details
- Greater surface area, for maximum filtration
- Pleated media may be washed off at least once
- Recommended for use in chlorinated water supplies only
- A quality and cost effective filter
The ECP50-20BB Pentek comparable replacement filter cartridge by Tier1 , is made of a pleated polypropylene for added dirt holding capacity. The pleats ensure more sediment is captured, compared to other types of sediment filters. The large surface area ensures greater filtration strength. Recommended only for chlorinated supplies, this easy to install filter needs replacement once every six months, for maximum performance. Pleated media may be washed off at least once, during the lifespan of the filter. This makes sure the filter is performing its best. Order today!
Experience the Tier1 Difference
Tier1 manufactures high-quality filtration and household products. We take creating and maintaining a healthy home seriously. Products must undergo rigorous testing and meet demanding quality expectations in order to earn the Tier1 badge. Every purchase is backed by the Tier1® Guarantee:
- Guaranteed Fit
- Guaranteed Quality
- Guaranteed Price
Reduced Contaminants
The TIER1-ECP50-20BB reduces the following contaminants:
- Dirt
- Fine Sand
- Hard Scale
- Rust and Corrosion
- Sediment
The TIER1-ECP50-20BB is comparable with the following part numbers
4PAY5 |
255496-43 |
Instructions
- Turn off water supply. Press red pressure-relief button (if present)
- Unscrew housing. Remove large o-ring, wipe clean and set aside
- Discard used filter cartridge
- Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
- Insert new filter cartridge
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation