Home >
EP5-10BB Tier1 Carbon Block Water Filter (4-Pack)

EP5-10BB Tier1 Carbon Block Water Filter (4-Pack)

$82.99

Quick Overview

Fits filtration system housings that accepts 10 x 4.5 inch cartridges

Qty:

More Views

EP5-10BB Tier1 Carbon Block Water Filter (4-Pack)

EP5-10BB Tier1 Carbon Block Water Filter (4-Pack) (Why Tier1?)

EP5-10BB Tier1 Carbon Block Water Filter (4-Pack) (What We Filter)

EP5-10BB Tier1 Carbon Block Water Filter (4-Pack) (Great Water Great Life)

Details

Built to capture sediment as small as 5 microns, while reducing chlorine taste and odor, the EP5-10BB (4-Pack) Tier1 carbon block water filter helps ensure you continue to serve only great tasting water of the highest quality. Installs quickly and easily into housings that accept 10 x 4.5 inch cartridges. For best results, replace once every three to six months, based on the water quality in your area. Serve great tasting, high quality water in your home or business by ordering and installing the EP5-10BB carbon block water filter from Tier1. Order today!

Ships fast!
Reduces chlorine taste and captures sediment as small as 5 microns
Ensures you continue to serve great tasting, high quality water in your home or business!

Specifications

Package Qty	4
Used In Brands	Tier1
Manufacturer's Id	EP5_10BB_4_PACK
UPC	635510434375
Advertised Size (in)	10 x 4-1/2
Actual Size (in)	9.5 inches (length) x 4.5 inches (outside diameter)
Actual Size (cm)	24.13 x 11.43
Media	Powder Activated Carbon Block
Primary Filter Media	Activated Carbon Block
Filter Life (gallons)	1,500
Filter Life (liters)	5,678.12
Filter Life (months)	24 months
Micron Rating (Nominal)	5
Operating Temperature (°F)	40 - 180
Operating Temperature (°C)	4.4 - 82.2
Flow Rate (gpm)	2
Flow Rate (lpm)	7.57
Warranty Guarantee	Unconditional Product Guarantee for Life of the Product

Contaminants

Reduces the following contaminants:

Bad Taste and Odor
Chlorine Taste & Odor
Sediment

Instructions

1. Turn off water supply. Press red pressure-relief button (if present).
2. Unscrew housing. Remove large o-ring, wipe clean and set aside.
3. Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
4. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
5. Insert new filter cartridge
6. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
7. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.