Home >
EP-20 Pentek Comparable Replacement Filter Cartridge by Tier1 (50-Pack)

EP-20 Pentek Comparable Replacement Filter Cartridge by Tier1 (50-Pack)

$551.99

Quick Overview

Fits sized 20 x 2.5 inches

Qty:

More Views

EP-20 Pentek Comparable Replacement Filter Cartridge by Tier1 (50-Pack)

EP-20 Pentek Comparable Replacement Filter Cartridge by Tier1 (50-Pack) (Why Tier1?)

EP-20 Pentek Comparable Replacement Filter Cartridge by Tier1 (50-Pack) (What We Filter)

EP-20 Pentek Comparable Replacement Filter Cartridge by Tier1 (50-Pack) (Great Water Great Life)

Details

By reducing chlorine taste and odor, in addition to sediment particles 5 micron or larger, the EP5-20 (50-Pack) Tier1 carbon block water filter helps to significantly improve the quality of water in your entire home. Sized to fit into any filtration system that uses 20 x 2.5 inch filter cartridges. Drink, serve and use and high quality water you deserve by ordering the EP5-20 Tier1 carbon block water filer today!

Ships fast!
Reduces chlorine taste, odor and sediment 20 micron or larger
Ensures you drink, serve and use only the highest quality water!

Specifications

Package Qty	50
Used In Brands	Tier1
Manufacturer's Id	EP5_20_50_PACK
UPC	635510436119
Advertised Size (in)	20 x 2-1/2
Actual Size (in)	19 7/8 inches (length) x 2 1/2 inches (outside diameter)
Actual Size (cm)	50.4825 x 6.35
Media	Powder Activated Carbon Block
Primary Filter Media	Activated Carbon Block
Micron Rating (Nominal)	5
Operating Temperature (Â°F)	40 - 180
Operating Temperature (Â°C)	4.4 - 82.2
Flow Rate (gpm)	2
Flow Rate (lpm)	7.5708
Color / Finish	White
Warranty Guarantee	Unconditional Product Guarantee for Life of the Product

Contaminants

Reduces the following contaminants:

Bad Taste and Odor
Chlorine Taste & Odor
Particulates

Instructions

1. Turn off water supply. Press red pressure-relief button (if present).
2. Unscrew housing. Remove large o-ring, wipe clean and set aside.
3. Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
4. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
5. Insert new filter cartridge.
6. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
7. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.