Installation Instructions

Download Instruction Sheet

1. Slide Perma-Boot over PVC pipe until it contacts existing pipe-boot or roof (base of boot swivels to fit pitch of roof)
2. Apply bead of adhesive* on top surface of Perma-Boot
3. Apply bead of adhesive* on top surface of PVC pipe
4. Slide cap over PVC pipe until it is fully engaged

*Use a non-silicone-based roofing adhesive. We include Geocel 2321 adhesive with every order, but any non-silicone roofing adhesive will work

Helpful Tips

• Brittle PVC Pipe
  PVC pipe can become brittle from years of exposure, so handle it carefully. It could snap if you pull on it.
• 1-1/2 inch PVC Pipe
  When installing the Perma-Boot on 1-1/2 inch (inside diameter) pipes, the boot will not fit snugly around the pipe. This is normal, the cap will secure the boot.
• "Loose" PVC Pipe
  If your PVC pipe moves downward while installing the boot, you may need to pull the pipe up while sliding the boot down so that the boot stays in contact with the roof.
• PVC Pipe Length
  In most areas, building code states that the PVC pipe must be 12 inches above the roof. The Perma-Boot can handle a few inches of variation from this, but if your pipe is really long or really short you may need to either cut it down to size, or use some PVC pipe fittings to extend it.
• Personal Safety
  Please read our list of Safety Warnings prior to installation.