We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
FLOPLUS-20BB Pentek Replacement Filter Cartridge
SKU
PENTEK-FLOPLUS-20BB
Price $122.99 List Price Price $175.99 Save 30%
Availability: In Stock - Free Shipping
Fits most Big Blue housings that accept 20-inch x 4.5-inch water filter cartridges
- Product cannot ship to California, Iowa, or Wisconsin
- Revolutionary new technology that significantly enhances the traditional Fibredyne
- Dirt-holding ability of a 10-micron carbon block with the particulate efficiency of a 0.5-micron cartridge
- High flow and low pressure drop, with the advantage of infrequent cartridge changes
› See more product details
- Product cannot ship to California, Iowa, or Wisconsin
- Revolutionary new technology that significantly enhances the traditional Fibredyne
- Dirt-holding ability of a 10-micron carbon block with the particulate efficiency of a 0.5-micron cartridge
- High flow and low pressure drop, with the advantage of infrequent cartridge changes
The Pentek FloPlus-20BB carbon filter is a great alternative for applications where pressure drop and low flow have been chronic problems in the past. This is a filter featuring premium dirt-holding capacity, combined with outstanding reduction of unpleasant taste & odor issues. It provides further assurance of water free of particulates as small as cysts. In fact, the FloPlus-20BB reduces up to 99.95% of Cryptosporidium and Giardia cysts. It has been tested and certified to NSF/ANSI Standard 53 for cyst filtration.
Reduced Contaminants
The PENTEK-FLOPLUS-20BB reduces the following contaminants:
- Chlorine Taste & Odor
- Cryptosporidium 99.95%
- Cysts
- Giardia 99.95%
The PENTEK-FLOPLUS-20BB is comparable with the following part numbers
455906-43 |
FLOPLUS-20BB |
User Guide
Instructions
- Turn off water supply. Press red pressure-relief button (if present).
- Unscrew housing. Remove large o-ring, wipe clean and set aside.
- Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly.
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove.
- Insert new filter cartridge.
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.