Home >
20 inch x 2.5 inch Pleated Polyester Sediment Water Filter Kit by Tier1 (5 Micron)

20 inch x 2.5 inch Pleated Polyester Sediment Water Filter Kit by Tier1 (5 Micron)

$13.99

Qty:

More Views

SPC-25-2005 Hydronix Pleated Polyester Filter Cartridge Comparable Replacement Kit with O-ring and Lubricant by Tier1 (2.5 inches x 20 inches, 5 Micron)

Details

The 20 x 2.5 inch pleated polyester filter replacement kit by Tier1 includes everything you need for filter change maintenance. The exclusive kit includes a 5 micron pleated polyester filter, replacement O-ring, and lubricant packet to make your next filter change a breeze. The experts at Tier1 have worked hard to ensure this kit contains the filter and component you need to finish the job. Water taste and quality is critical business, the pleated polyester sediment water filter kit by Tier1 captures dirt, sand and sediment down to 5 microns. The filter replacement kit installs quickly and easily, order today!

Ships fast!
Includes filter, o-ring and lubricant packet
Manufactured for performance, priced for value
Pleated design ensures greater dirt holding capacity

Specifications

Package Qty	3
Used In Brands	Tier1
Manufacturer's Id	FHR-20-25-PLEATED
UPC	641945752311
Advertised Size (in)	20 x 2-1/2
Actual Size (in)	20 inches (length) x 2 1/2 inches (outside diameter)
Actual Size (cm)	50.8 x 6.35
Primary Filter Media	Pleated Polyester
Filter Life (months)	6 months
Micron Rating (Nominal)	5
Operating Temperature (°F)	40 - 125
Operating Temperature (°C)	4.4 - 51.7
Flow Rate (gpm)	20
Flow Rate (lpm)	75.708
Color / Finish	White
Warranty Guarantee	Unconditional Product Guarantee for Life of the Product
Includes	SPC-25-2005 Hydronix Comparable Replacement Filter, replacement O-ring, and lubricant packet
Primary Filter Media	Pleated Polyester

Instructions

1. Turn off water supply. Press red pressure-relief button (if present)
2. Discard used filter cartridge
3. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
4. Insert new filter cartridge
5. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
6. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
7. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
8. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation

The TIER1_FHR_20_25_PLEATED_KIT is comparable with the following part numbers