We use cookies to make your experience better.
RFC-20BB Whole House Filter Replacement Cartridge by Tier1
SKU
TIER1-RFC-20BB
Price $37.99 List Price Price $53.99 Save 29%
Availability: In Stock
Fits most 20X4.5 housings
Choose a quantity
1 Filter $37.99 -
2 Filters Price $36.85 each -
3 Filters Price $35.74 each
- Big Blue sized filter cartridge, provides greater surface area
- High flow rate
- Filter life of 100,000 gallons
- Reduces contaminats such as chlorine taste and odor
› See more product details
- Big Blue sized filter cartridge, provides greater surface area
- High flow rate
- Filter life of 100,000 gallons
- Reduces contaminats such as chlorine taste and odor
The RFC-20BB Whole House Filter Replacement Cartridge by Tier1 provides a large surface area, which increases filtration effectiveness. This greater surface area in turn allows a high flow rate. This filter will last you up to 6 months, or every 100,000 gallons which equates to 4 gallons per minute, whichever comes first. This typically evens out to only 2-3 filter changes per year. The Tier1 RFC-20BB does an exceptional job of taking out chlorine taste an odor, or your money back!
Experience the Tier1 Difference
Tier1 manufactures high-quality filtration and household products. We take creating and maintaining a healthy home seriously. Products must undergo rigorous testing and meet demanding quality expectations in order to earn the Tier1 badge. Every purchase is backed by the Tier1® Guarantee:
- Guaranteed Fit
- Guaranteed Quality
- Guaranteed Price
Reduced Contaminants
The TIER1-RFC-20BB reduces the following contaminants:
- Chlorine Taste & Odor
- Rust and Corrosion
The TIER1-RFC-20BB is comparable with the following part numbers
PENTEK-RFC20-BB |
Instructions
- Turn off water supply. Press red pressure-relief button (if present)
- Unscrew housing. Remove large o-ring, wipe clean and set aside
- Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
- Insert new filter cartridge
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation