We use cookies to make your experience better.
D-250A Culligan Undersink Filter Replacement Cartridge Set
SKU
CULLIGAN-D-250A
Price $60.99 List Price Price $86.99 Save 29%
Availability: In Stock - Free Shipping
Fits the Culligan SY-2300, SY-2300S and SY-2650 systems and any brand of undersink water filter system that uses standard 9 3/4 x 2 1/2 filter cartridges
- Replacement cartridge set provides the highest standard of water quality for your Culligan or under sink filtration system
- Fast shipping!
- Assembled in the USA from a mix of foreign and domestic parts
- Genuine OEM part
› See more product details
- Replacement cartridge set provides the highest standard of water quality for your Culligan or under sink filtration system
- Fast shipping!
- Assembled in the USA from a mix of foreign and domestic parts
- Genuine OEM part
The Culligan D-250A drinking water replacement cartridge set provides better water, pure and simple.
Package Qty | 1 |
---|---|
Used In Brands | Culligan |
Manufacturer's Id | D-250A |
UPC | 033663005693 |
Advertised Size (in) | 10 x 2-1/2 |
Actual Size (in) | 9 3/4 inches (length) x 2 1/2 inches (outside diameter) |
Actual Size (cm) | 24.77 x 6.35 |
Outside Diameter (inches) | 2.5 |
Media | Granular Carbon and Carbon Block |
Primary Filter Media | Granular Activated Carbon |
Pre Filter Media | Activated Carbon Block |
Filter Life (gallons) | 500 |
Filter Life (liters) | 1,892.71 |
Filter Life (months) | 6 months |
Micron Rating (Nominal) | 0.5 |
Country of Manufacture | United States |
Certifications | NSF/ANSI Standard 42 |
Includes | One Granular Carbon Cartridge, One Carbon Block Cartridge |
Primary Filter Media | Granular Activated Carbon |
Reduced Contaminants
The CULLIGAN-D-250A reduces the following contaminants:
- Asbestos
- Bad Taste and Odor
- Chlorine Taste & Odor
- Cysts
- Lead
- Mercury
- Pesticides
- Sand
- Sediment
- Turbidity
- VOCs
The CULLIGAN-D-250A is comparable with the following part numbers
039861-WI-001 | 155584-44 | D250 | D250A |
D-250A | P250 | P-250 | P250A |
P-250A | SY-2300 | SY-2300S | SY-2650 |
W250 | W-250 | 1019067 |
Instructions
- NOTE: Install the Culligan D-250A water filters with the black gasket end pointing up.
- Turn off water supply. Press red pressure-relief button (if present)
- Unscrew housing. Remove large o-ring, wipe clean and set aside
- Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
- Insert new filter cartridge
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation