We use cookies to make your experience better.
RFC-BB Pentek Whole House Water Filter Cartridge Replacement
SKU
PENTEK-RFC-BB
Price $56.99 List Price Price $80.99 Save 29%
Availability: BackOrder
Fits water filtration system housings by Pentek, Culligan, Pentair, Ametek, US Filter, Kleen Plus, Bruner, American Plumber, Plymouth and more that accept 9-3/4 x 4-1/2 inch filter cartridges
Choose a quantity
1 Filter $56.99 -
6 Filters Price $51.29 each
- Ships fast!
- Reduces organic sediment, chlorine taste and odor
- Ensures you drink the highest quality water for up to six months after installation
› See more product details
- Ships fast!
- Reduces organic sediment, chlorine taste and odor
- Ensures you drink the highest quality water for up to six months after installation
Built to reduce organic sediment, chlorine taste and odor, the RFC-BB Pentek whole house water filter cartridge fits easily into any filtration system housing that accepts 9-3/4 by 4-1/2 inch filter cartridges. For up to six full months or 35,000 gallons of average usage, this filter will capture nearly all sediment 25 micron or larger while granular activated carbon to reduce impurities that can impact taste. Ideal for use with both municipal or well water. Order the FC-BB Pentek whole house water filter cartridge you need today!
Reduced Contaminants
The PENTEK-RFC-BB reduces the following contaminants:
- Chlorine Taste & Odor
- Dirt
- Sand
- Sediment
- Silt
- VOCs
The PENTEK-RFC-BB is comparable with the following part numbers
48169 | 155141 | 155141-27 | 155141-30 |
155141-43 | 155141-51 | RFC-BB | RFC-BBS |
RFC-BBSA | RFC-BBSA-D | RFC-BBS-D | TO8 |
TO8-2-01 | TO8-2-02 | TO8-2-05 | TO8-R-05 |
W5CBHD | WRC25HD |
User Guide
Instructions
- Turn off water supply. Press red pressure-relief button (if present).
- Unscrew housing. Remove large o-ring, wipe clean and set aside.
- Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly.
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove.
- Insert new filter cartridge.
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.