Refrigerator Filters
  • Whole House Filtration
  • Air Filters
  • Water Filters
  • Does Reverse Osmosis Remove PFAS? What Certification Actually Proves

    November 02, 2026 8 min read

    EPA lists reverse osmosis among the home filter types that can reduce PFAS, but only an RO system tested for PFAS reduction can make that claim. Look for NSF/ANSI 53 or NSF/ANSI 58 certification showing a PFOA and PFOS reduction claim, or a total PFAS claim, on the Performance Data Sheet or the certifier's database. Home RO treats the kitchen tap only, needs on-schedule replacement, and EPA says certification standards do not yet show removal to its 4.0 ppt limits.

    Explore

    Shop Under-Sink RO Systems

    Comparing RO systems for PFAS? Browse under-sink reverse osmosis systems and replacement filters, then check each model's certification listing for a PFOA and PFOS claim.

    What EPA Says About Reverse Osmosis and PFAS

    EPA says reverse osmosis is one of the home filter types that can reduce PFAS, and it tells shoppers to check for NSF/ANSI 53 or 58 certification. PFAS, or forever chemicals, include PFOA and PFOS; DFS's PFAS guide covers the basics. If you are comparing RO water filters, check each certification listing.

    Table 1 shows what each source says and what it does not say. No row gives a removal percentage.

    Table 1. What Each Source Says About RO and PFAS

    Source Statement (paraphrased) What it does NOT say
    EPA home filter fact sheet (Aug 2026) RO can reduce PFAS; look for NSF/ANSI 53 or 58 That every RO system reduces PFAS
    EPA treatment fact sheet (Apr 2024) RO and nanofiltration are Best Available Technologies for utilities That home units are compliance options
    EPA WaterSense RO specification Labels report total PFAS, certified or not That the label means PFAS-certified
    Penn State Extension Look for PFOA and PFOS Reduction claims That certified devices reach EPA's MCLs

    EPA lists RO as a filter type that can reduce PFAS

    EPA's home filter fact sheet lists reverse osmosis as a filter type that can be effective at reducing PFAS, alongside granular activated carbon and ion exchange resins. EPA's guide to reducing PFAS with a home filter says to check the packaging for NSF/ANSI 53 or 58 certification for PFAS reduction. EPA also says a filter may not be useful if PFAS have not been detected in your water or are below federal limits.

    Why this post gives no single removal percentage

    This post gives no single PFAS removal percentage for reverse osmosis because none of the sources behind this guide, EPA, NSF and Penn State Extension, gives one for home RO systems. Results depend on the system's certified claim, so check the Performance Data Sheet.

    RO membrane plus carbon polishing stage

    The RO membrane and the carbon stages, including any carbon polishing stage, are both parts of a point-of-use reverse osmosis system, and Penn State Extension lists replacement times for both. DFS's reverse osmosis hub explains how the membrane works. NSF says PFOA and PFOS claims were first added to NSF/ANSI 53 for activated carbon, in its 2018 edition.

    Replacement reverse osmosis carbon cartridges should match your system's maker and model. The certification listing, not the part name, shows whether the system carries a PFAS claim.

    How to Check an RO System's PFAS Certification

    To check an RO system's PFAS certification, find a PFOA and PFOS reduction claim, or a total PFAS claim, under NSF/ANSI 53 or NSF/ANSI 58 on its certification listing. A product title that says "reduces PFAS" is not a certified claim. Table 2 shows what each claim means.

    How to read the PFAS claim on a reverse osmosis system: RO alone or reduces PFAS with no standard is not a certification; PFOA and PFOS or total PFAS reduction under NSF/ANSI 53 or 58 is.

    Table 2. Reading the PFAS Claim on an RO System

    Claim you see What it means How to verify
    "Reverse osmosis" only No PFAS claim Performance Data Sheet
    "Reduces PFAS", no standard named Not a certification Ask for the certification listing
    PFOA and PFOS reduction, NSF/ANSI 53 or 58 Tested for those two PFAS Certifier database
    Total PFAS reduction Broader PFAS claim Certification listing
    1. Find the exact model number.
    2. Look for "PFOA reduction," "PFOS reduction" or total PFAS on the Performance Data Sheet.
    3. Search the certifier's directory for that model; no PFAS claim means not certified for PFAS.

    NSF/ANSI 53 and 58 claims: PFOA and PFOS

    NSF/ANSI 53 and NSF/ANSI 58 PFAS claims, as EPA and Penn State Extension describe them, are PFOA reduction and PFOS reduction claims. EPA says that as of April 2024, certifications focus on PFOA and PFOS. Penn State Extension's home water treatment guide for PFAS says to look for "PFOA Reduction" and "PFOS Reduction" claims.

    NSF's own NSF/ANSI 58 page lists TDS reduction as the only required claim and does not list a PFOA or PFOS claim. Check that the specific system's certification listing shows a PFOA or PFOS reduction claim.

    Total PFAS versus PFOA and PFOS only

    A total PFAS claim is broader than a PFOA and PFOS claim, because it covers PFAS as a group rather than two named compounds. According to a 4 Dec 2023 NSF release, the 2022 edition of NSF/ANSI 53 expanded claims to PFHxS, PFNA, PFHpA, PFBS and PFDA.

    Where to find the claim: Performance Data Sheet and certifier database

    The PFAS claim for an RO system appears on its Performance Data Sheet and in the certifier's product listing. EPA names five ANSI-accredited certifiers: CSA Group, IAPMO R&T, NSF, UL and WQA. Penn State Extension suggests filtering the NSF and WQA databases by PFOA or PFOS.

    For comparison, the Pentair FloPlus Protect 20BB, a whole-house carbon cartridge rather than an RO system, is certified to NSF/ANSI 53 by IAPMO R&T for the reductions on its Performance Data Sheet.

    WaterSense RO labels report total PFAS

    EPA WaterSense RO labels must report total PFAS, and a system without a verified PFAS claim must state that it is not certified for PFAS. The EPA WaterSense specification for RO systems requires NSF/ANSI 58 certification, TDS reduction of at least 75% and minimum efficiency of 30%. It also cites ASSE 1086, the RO water-efficiency standard, for membrane life testing.

    EPA PFAS Limits for Drinking Water in 2026

    As of 27 Oct 2026, EPA's PFAS rule sets a 4.0 ppt MCL for PFOA and for PFOS, while the limits for PFHxS, PFNA, HFPO-DA and the Hazard Index are proposed for rescission. EPA's PFAS drinking-water rule page was last updated 18 May 2026, when EPA announced two proposals that are not final. Re-check epa.gov before relying on these dates.

    Table 3 lists each 2024 limit and its status. Compliance is based on annual averages.

    Table 3. EPA PFAS Drinking-Water Limits, Status as of 27 Oct 2026

    PFAS 2024 limit (MCL) Status in 2026
    PFOA 4.0 ppt Kept; 2031 deadline proposed
    PFOS 4.0 ppt Kept; 2031 deadline proposed
    PFHxS 10 ppt Rescission proposed (not final)
    PFNA 10 ppt Rescission proposed (not final)
    HFPO-DA (GenX) 10 ppt Rescission proposed (not final)
    Hazard Index 1 Rescission proposed (not final)

    EPA PFAS drinking-water rule timeline as of October 2026: final rule 2024, initial monitoring 2027, exceeding systems act by 2029, 2031 proposed for PFOA and PFOS.

    PFOA and PFOS: 4.0 ppt

    PFOA and PFOS each have an MCL of 4.0 ppt (ng/L) and an MCLG of zero under EPA's 2024 PFAS rule. On 14 May 2025, EPA announced it would keep both MCLs.

    PFHxS, PFNA, GenX and the hazard index: proposed rescission

    PFHxS, PFNA and HFPO-DA (GenX) each have a 10 ppt MCL, and a Hazard Index MCL of 1 covers mixtures of PFHxS, PFNA, HFPO-DA and PFBS. On 18 May 2026, EPA proposed rescinding all four limits; the proposal is not final as of 27 Oct 2026.

    Compliance dates: 2029 now, 2031 proposed for PFOA and PFOS

    EPA's PFAS rule sets initial monitoring by 2027 and gives water systems that exceed an MCL until 2029, with 2031 proposed for PFOA and PFOS. 2027 is the monitoring deadline, not the compliance deadline. The 18 May 2026 proposal would let systems request two more years, to 2031.

    What Home RO Can and Cannot Do for PFAS

    Home RO can reduce PFAS at the kitchen tap when it is certified for PFAS, but it treats one tap, sends rejected water to the drain and works only when maintained. Table 4 summarizes each limit.

    Table 4. Limits of Home RO for PFAS

    Limit What to know Source
    Point-of-use only Treats one tap; not a utility compliance option EPA
    Drain water Carries away what the membrane rejects EPA; WaterSense
    Certification vs MCL Standards don't yet show removal to EPA's levels EPA
    Upkeep Missed replacements can increase exposure EPA; Penn State

    Point-of-use: the kitchen tap only

    A point-of-use RO system treats water only at the tap it serves, so showers, appliances and other faucets still get untreated water. EPA has not designated point-of-use or point-of-entry devices as compliance options for utilities, because the rule's levels are below current ANSI/NSF certification standards.

    Drain water carries the rejected PFAS

    Drain water from an RO system, also called the reject stream, carries away what the reverse osmosis membrane rejects. At utility scale, EPA's PFAS treatment fact sheet puts the reject stream at about 20% of influent, with PFAS concentrated roughly 5x, and calls brine disposal the major challenge.

    For WaterSense-labeled home systems, the minimum efficiency is 30%. At that minimum, 70 ÷ 30 = about 2.3 gallons go to the drain per gallon treated.

    Replacing filters and the membrane on schedule

    Replacing RO filters and the reverse osmosis membrane on schedule matters for PFAS, because EPA says missed replacements can increase PFAS exposure. Penn State Extension gives about 6–12 months for carbon blocks and 12–24 months for RO cartridges, but your manual sets the replacement interval. Choose a home water filter membrane that matches your system's model.

    💡 Editor's Pick

    Is your RO membrane due? EPA says missed replacements can increase PFAS exposure, so match a replacement membrane to your system's model and keep it on schedule.

    Shop RO Membranes →

    Frequently Asked Questions

    Can a reverse osmosis system remove all PFAS?

    No source used here shows that a reverse osmosis system removes all PFAS, and EPA says certification standards do not yet show removal to its drinking-water levels. Certifications have focused on PFOA and PFOS, so check which PFAS the listing covers.

    Is NSF/ANSI 58 certification enough for PFAS?

    NSF/ANSI 58 certification alone is not enough for PFAS, because NSF says TDS reduction is the only required claim. Check the listing for a PFOA or PFOS reduction claim. If you have seen NSF/ANSI P473, note that EPA points to NSF/ANSI 53 and 58 PFAS claims instead.

    How often should I replace the RO membrane for PFAS reduction?

    Replace the RO membrane on your system manual's schedule, because EPA says filters work only when maintained and missed replacements can increase exposure. Penn State Extension's general range for RO cartridges is about 12–24 months, but your manual sets the actual interval.

    Should I choose RO or a carbon filter for PFAS?

    Either RO or a carbon filter can work for PFAS, since EPA lists reverse osmosis and granular activated carbon among filter types that can reduce PFAS. The deciding factor is a certified PFAS claim on the specific product. DFS's PFAS guide compares filter types.

    Does boiling remove PFAS from RO water?

    Boiling is not listed as a PFAS treatment in EPA's home filter fact sheet, which points to certified filters such as reverse osmosis instead. If your RO system carries a PFAS claim, its Performance Data Sheet shows what it was tested for.


    Sources