CL-12 Clairify Whole House Inline Filter
- No power requirements or use of potentially dangerous chemicals
- Supports a flow rate of up to 12 gallons per minute (gpm)
- Uses Charged ceramic beads to significantly reduce microorganisms
- Provides filtered water throughout your home as a point of entry filter
NOTE:This product is designed for cold water use only, less than 100 degrees F (38 degrees C). Passing hot water through this product will damage the system.
NOTE: System must be installed in a vertical, upright and level position.
NOTE: It is recommended to install this system after a pre-filter (nominal 5 microns) to protect the unit from risk of damage from suspended solids. Solids can clog the activated surfaces of the media and irreversibly inhibit their germicide properties.
|Used In Brands||Clairify|
|Actual Size (in)||11 inches (Length) x 3 inches (Width)|
|Actual Size (cm)||28 x 7.6|
|Media||Charged Ceramic Beads|
|Filter Life (gallons)||200,000|
|Filter Life (liters)||740,000|
|Operating Pressure (psi)||20 - 125|
|Maximum Operating Pressure (psi)||125|
|Operating Temperature (°F)||40 - 100|
|Operating Temperature (°C)||4.4 - 38|
|Flow Rate (gpm)||12|
|Flow Rate (lpm)||44.4|
|Fitting Size (inches)||1 inch|
|Certifications||Independently Tested against NSF/ANSI Standard 42, NSF/ANSI Standard 61|
|Primary Filter Media||Ceramic Beads|
The CLARIFY-CL-12 reduces the following contaminants: