We use cookies to make your experience better.
Service Updates
Our call centers will be closed Monday, May 29th for Memorial Day. We will be available again starting Tuesday, May 30th from 8am - 5pm CST.
20 inch x 4.5 inch Whole House Pleated Polyester Water Filter by Tier1 (5 Micron)
1 filter $32.99 2 filters $32.00 each 3 filters $31.04 each 4 filters $30.59 each 6 filters $29.69 each 12 filters $24.74 each
- Ships fast!
- Ensures quality water throughout your home
- Easy installation for a frustration-free return to better water
- Pleated polyester media reduces particles down to 5 microns
- Ships fast!
- Ensures quality water throughout your home
- Easy installation for a frustration-free return to better water
- Pleated polyester media reduces particles down to 5 microns
Experience the Tier1 Difference
Tier1 manufactures high-quality filtration and household products. We take creating and maintaining a healthy home seriously. Products must undergo rigorous testing and meet demanding quality expectations in order to earn the Tier1 badge. Every purchase is backed by the Tier1® Guarantee:
- Guaranteed Fit
- Guaranteed Quality
- Guaranteed Price
Reduced Contaminants
The TIER1-ECP5-20 reduces the following contaminants:
- Dirt
- Particles
- Sand
- Sediment
- Silt
The TIER1-ECP5-20 is comparable with the following part numbers
255494-43 |
255496-43 |
4PAY5 |
Pentek ECP5-20BB |
The TIER1-ECP5-20 fits the following model numbers
W20FFPH1CBPR |
CFS22 |
Instructions
- Turn off water supply. Press red pressure-relief button (if present)
- Unscrew housing. Remove large o-ring, wipe clean and set aside
- Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
- Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
- Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
- NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
- Insert new filter cartridge
- Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
- Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation