We use cookies to make your experience better.
Service Updates
Our call centers will be closed Monday, May 29th for Memorial Day. We will be available again starting Tuesday, May 30th from 8am - 5pm CST.
QS-330 Viqua Replacement Quartz Sleeve
SKU
VIQUA-QS-330
Price $49.00 List Price Price $69.99 Save 29%
Availability: In Stock
Only 3 left
- Genuine VIQUA Sterilight QS-330 Quartz Sleeve
- Compatible with VIQUA Sterilight R-Can VT4, VTV/2, S2Q-PA, S2Q-PA/2, S2Q, S2Q/2, S2Q-GOLD, S2Q-GOLD/2, SSM-17, SSM-17/2 UV Systems
- Viqua Sterilight Replaces the Brands R-Can and Sterilume
- VIQUA UV system will disinfect against microbiological contaminants, providing you and your family with treated drinking water
› See more product details
Save $17.01 with USWF Water Treatment
View Filter Value Comparison

- Genuine VIQUA Sterilight QS-330 Quartz Sleeve
- Compatible with VIQUA Sterilight R-Can VT4, VTV/2, S2Q-PA, S2Q-PA/2, S2Q, S2Q/2, S2Q-GOLD, S2Q-GOLD/2, SSM-17, SSM-17/2 UV Systems
- Viqua Sterilight Replaces the Brands R-Can and Sterilume
- VIQUA UV system will disinfect against microbiological contaminants, providing you and your family with treated drinking water
Save $17.01 with USWF Water Treatment
View Filter Value Comparison

The QS-330 Sterilight UV quartz sleeve is used with the S2Q-PA system and comes with 2 o-rings. Minerals in your water will coat the quartz sleeve over time with use, this coating must we cleaned off to prevent a reduction in filtration performance. When the quartz sleeve can not be cleaned then it must be replaced.
Specs End type: Open Ended ID: 0.79" or 20mm ± .2mm OD: 0.91" or 23mm ± .2mm Length: 14.76" or 375mm ± 3.5mm
Specs End type: Open Ended ID: 0.79" or 20mm ± .2mm OD: 0.91" or 23mm ± .2mm Length: 14.76" or 375mm ± 3.5mm
The VIQUA-QS-330 is comparable with the following part numbers
R-Can VT4, VTV/2, S2Q-PA, S2Q-PA/2, S2Q, S2Q/2, S2Q-GOLD, S2Q-GOLD/2, SSM-17, SSM-17/2 |
Installation Guide
Instructions
- Close the main water supply to the UV System, and then open a tap downstream of the UV System to release pressure.
- Disconnect the main power source and allow the unit to cool for 10 minutes.
- Remove the top retaining nut and O-ring.
- Remove the bottom retaining nut, spring, and loosen the Oring to drain the water. NOTE: Ensure that the quartz sleeve does not slide through.
- Remove the quartz sleeve from the UV chamber.
- Clean the quartz sleeve with a cloth soaked in CLR, vinegar, or some other mild acid, and then rinse with water.
- Re-insert the quartz sleeve with O-ring(s), spring, and retaining nut(s).
- Hand tighten the retaining nut(s), taking care not to over-tighten.