Refrigerator Filters
  • Whole House Filtration
  • Air Filters
  • Water Filters
  • PENTEK-DGD-7525-20

    DGD-7525-20 Pentek Whole House Replacement Sediment Filter Cartridge

    Low Stock (4)
    Fits most housings that accept 20-inch x 4.5-inch water filter cartridges
    Price Per Item
    2 PACK $33.66
    4 PACK $32.61
    6 PACK $31.57
    24 PACK $30.53
    Choose a Pack Size:
    • Reduces the need for multiple housing step-down filtration systems

    • Filters extra-fine dirt, sand, sediment, silt, rust particles, and scale particles effectively

    • Bacteria resistant and chemical resistant

    • 3 times the dirt-holding capacity of similar sized sediment water filters

    Features & Specs
    Package Qty: 1
    Manufacturer: Pentair Water
    Manufacturer's Id: DGD-7525-20
    UPC: 051678356432
    Actual Size (in): 20 inches (Length) x 4-1/2 inches (Outside Diameter)
    Media: Spun Wound Polypropylene
    Primary Filter Media: Polypropylene
    Operating Temperature (°F): 40 - 145
    Operating Temperature (°C): 4.4 - 62.8
    Brand: Pentek
    Advertised Size: 20 x 4-1/2
    Length (in): 20 in
    Outside Diameter (in): 4.5 in
    Width (in): 4.5 in
    Media Type: Sediment Filter
    Country of Origin: China
    Micron Rating Nominal: 25
    Flow Rate (gpm): 20.0
    Includes: One Pentek DGD-7525-20 20 x 4.5 inch Sediment Water Filter
    Instructions
    1. Turn off water supply. Press red pressure-relief button (if present).
    2. Unscrew housing. Remove large o-ring, wipe clean and set aside.
    3. Discard used filter cartridge. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly.
    4. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly.
    5. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove.
    6. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove.
    7. Insert new filter cartridge.
    8. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge.
    9. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation.
    Downloads
    Certifications
  • NSF/ANSI Standard 42
  • Contaminants Reduced
  • Dirt
  • Hard Scale
  • Rust and Corrosion
  • Sand
  • Fine Sand
  • Sediment
  • Extra Fine Sand
  • Filter Life
    Filter Life (gallons): 8,000
    Filter Life (months): 6 months

    The Pentek DGD-7525-20 Sediment Water Filter is dual gradient, meaning the outer layer acts as a pre-filter, filtering out larger particles than the inner layer of the filter. The outer layer is a 75 micron filter and the inner layer filters down to 25 micron, reducing smaller sediment--prolonging the useful life of the cartridge by filtering more efficiently. High quality construction and durability make these filters perfect for a variety of applications. These filters are a great value for various applications, on both city and well water.


    PENTEK-DGD-7525-20   is comparable with the following part number(s)

    • 4PCD5
    • 155356-43